3D Group Project #1
Test Cube or Die

Objective: TSWBAT work cooperatively in a team utilizing 3D slicing software and the 3D printer to successfully print a 30 mm cube or die.

Task: Your team will print a 30 mm cube or die using FlashPrint software, and summarize the settings used during the print.

Project Options:

• Euchre Cube  - http://www.thingiverse.com/thing:543397
  
• Test Cube - http://www.thingiverse.com/thing:477
  
• Futuristic Forerunner Die - http://www.thingiverse.com/thing:1040288
• Grading Die - http://www.thingiverse.com/thing:13550
• 6-Sided Die - http://www.thingiverse.com/thing:113451
• Portal Companion Cube - http://www.thingiverse.com/thing:13588

Process:

1. Select print object & download files.
2. Open in FlashPrint.
3. Center object to sit flat on the platform.
4. Scale so that outer dimensions are 30mm x 30mm x 30mm.
5. Set the extruder to Left Extruder.
6. Level the Platform on the actual printer (use on-board printer menu)
7. Print!
8. Adjust print settings as your group sees fit & record your settings on your Project Print Sheet:

                  -Check the Print When Slice Done box
                  -Select the correct Material Left
                  -Decide if you need Supports or Rafts
                  -Set your resolution to low, standard, or high
                  -Adjust Infill Density and Pattern
                  -Adjust Extruder and Platform Temperature for your material
     9. When ready to print, click OK.

After Printing:

• Evaluate your finished print.
• What went well?
• Were there any errors or problems? Research the possible cause of any problems and a way to resolve the problem for your next print.